Date: Mon, 24 Dec 2001 18:14:06 -0800 From: Karl Cunningham <karlc@..........> Subject: Re: WinSDR
Another aspect of the serial cable... I'm not sure it matters, but at each
end I jumpered CTS to RTS and DSR to DTR. This bypasses any hardware flow
control that might be configured in the UARTS in the computers.
Karl
--On Monday, December 24, 2001 16:04 -0800 Larry Cochrane
<cochrane@..............> wrote:
> Dick,
>
> On both the DB9 and DB25 the transmit and receive lines are on the same
> pins 2 and 3. Just make sure they are swapped. The ground on the DB25 is
> pin 7 and on the DB9 pin 5. So pin 5 on the DB9 should go to pin 7 on the
> DB25 connector and pin 2 on the DB9 should go to pin 3 on the DB25 and
> pin 3 to pin 2.
>
> -Larry
>
>
> At 06:54 PM 12/24/2001 -0500, you wrote:
>
> Larry,
>
> The cable I am using has a DB9 AND a DB25 on each end of the cable. I
> looked at Tommy's connector page but could not find the db9 connector.
> What should be the correct pins for the Return, Transmit and GND.
>
> Dick
>
>
>
> At 02:27 PM 12/24/01 -0800, you wrote:
>
> Dick,
>
> WinSDR will run fine under NT. Karl is running it under NT and I use
> Win2K. Win2K is very similar to NT. I would double check your RS-232
> cable. The GPS receiver connects up to the sdrservr system not the WinSDR
> computer.
>
> Regards,
> Larry
>
>
> At 05:00 PM 12/24/2001 -0500, you wrote:
>
> Hi and Merry Christmas to all!
>
> Does WinSDR run under NT? I have installed it on a laptop running NT.
> The sdrservr is on a dos machine. I am not getting any communication and
> have tried all available port settings. Also, should the GPS be hooked
> to the WinSDR or the sdrservr computer? I am using a Belkin file
> transfer serial cable that has a crossed null-modem wiring design.
>
> Dick
>
> __________________________________________________________
>
> Public Seismic Network Mailing List WinSDR
>
> To leave this list email WINSDR-REQUEST@.............. with the body of
> the message (first line only): unsubscribe
>
>
>
> __________________________________________________________
>
> Public Seismic Network Mailing List WinSDR
>
> To leave this list email WINSDR-REQUEST@.............. with the body of
> the message (first line only): unsubscribe
>
.